行业新闻
  • 您现在的位置:首页 > 新闻资讯 > 行业新闻 >
  • 万级无菌实验室装修应该注意什么?
    来源:http://www.jnyhrs.com 浏览: 发布日期:2020-11-26
    清理门洞,消除多余部分。保证门洞两侧都在垂直线上。
    Clean the door opening and remove the excess. Make sure both sides of the door opening are vertical.
    安装门框上的顶轴部分。
    Install the top shaft part on the door frame.
    用螺丝或者铆钉组合门框的三根型材。
    Use screws or rivets to assemble the three profiles of the door frame.
    安装地轴,在地上开出长170mm,宽120mm,深度为55mm的方形坑,浇注砂浆,固定地轴的时候,从顶轴的线垂直至地轴轴承的,固定好地轴,水泥干燥后进行下一步。
    Install the floor shaft, open a square pit with length of 170mm, width of 120mm and depth of 55mm on the ground, and pour mortar. When fixing the floor shaft, the center line of the top shaft is perpendicular to the center of the bearing of the floor shaft. Fix the floor shaft. After the cement is dried, proceed to the next step.
    无菌室装修
    安装门体上轴和下轴。
    Install the upper shaft and lower shaft of the door body.
    安装门体前,需要注意:松开门扇的防盗卡位螺丝;装门扇前,在地轴上抹上润滑黄油,以使门扇开合自如增加使用寿命。
    Before installing the door body, attention should be paid to: loosen the anti-theft locking screw of the door leaf; before installing the door leaf, grease the floor shaft to make the door open and close freely and increase the service life.
    调节门扇的前后左右和上下方向:松开盖板可以用扳手调节地轴的螺丝;调节门扇上的下轴,具体方法是调节下轴上的六棱螺丝,顺时针调节,门扇向上,逆时针调节,门扇向下。
    Adjust the front, back, left, right and up and down directions of the door leaf: loosen the cover plate and use a wrench to adjust the screw of the floor shaft; adjust the lower axis of the door leaf by adjusting the hexagonal screw on the lower axis clockwise, with the door leaf upward, and the door leaf downward.
    拧紧防盗卡位螺丝。
    Tighten the anti-theft card screw.
    本文由济南肯德基门窗整理发布,您是不是对这些内容有所了解了呢?更多的内容请点击:http://www.jnclmcc.com我们会有更多精彩内容等你查看。
    This article is organized and released by KFC doors and windows in Jinan. Do you have any understanding of these contents? For more information, please click: http://www.jnclmcc.com We'll have a lot more to see.